Banwood Bike Lights: Install & Use for Safe Rides

Quick answer

Install Banwood Bike Lights in minutes using the included silicone mounts — no tools required. Position the white light on the handlebar facing forward and the red light on the seat post pointing backward.

Step-by-step installation guide

1. Mount the front light: Slide the silicone band around the handlebar near the stem. Position the white light so it faces straight ahead, then stretch the band over the light body until snug. Common mistake: mounting too far to one side, causing the beam to point off the road.
2. Mount the rear light: Wrap the silicone band around the seat post, about 2 inches below the saddle. Attach the red light so it faces directly backward. Ensure the band sits on bare metal or plastic, not on a reflector or bag strap. Checkpoint: the light should not wobble when you tap it sideways.
3. Choose your mode: Press the button on each light to cycle through steady, flash, and pulse. For daytime visibility, use flash or pulse. For dark trails, steady mode gives a constant beam. Reminder: turn off lights when not in use to save battery.
4. Test before every ride: Press the button briefly to confirm both lights are working. Ask your child to sit on the bike and check that the beams are not blocked by their body or the basket. Make it a habit: a quick button press takes two seconds and prevents riding unseen.

Product details

• BANWOOD BIKE LIGHTS: Front white light and rear red light with three modes: steady, flash, and pulse. You can adjust the mode based on riding conditions — use steady on dark paths, flash or pulse in low light to catch drivers' attention.